custom street rods guide

 

 

 

Building A Bmx Bunny Hop Trainer.
By Written by, Thu Dec 8th

Learning to get enough height to start grinding and stalling canbe a real challenge for the beginning BMX biker. Here issomething that can be built and used to get the heights needed.The best part about it that it is cheap and easy to build.Materials can found at your local lumber/hardware store. Thematerials needed are as follows; 2-2"x4"x3'board 1-1/2"x8' pieceof hard plastic water pipe. 20-2" finish nails. 1-3/4"x1'x4'plywood 4-3"deck screws

With the materials assemble as the diagram illustrates. "You cansee the detailed picture at www.evilbmx.biz under articles page".

The 3" deck screws come up from the bottom of the plywood intothe 2"x4"x3' boards. The finishing nails are nailed into theboard about ½" to ¾" The nails provide a place for the plasticpipe to hang. You can put the nails 1" apart going up on eachside.


Using

 

 

 
 
  Here are some articles to start with..  
 
 

The Last Of The 455 Pontiac Trans Ams
By Sue and Chuck DeFiore, Tue Dec 6th
Those of us lucky enough to be around in the 70s when thisfantastic car came out drool every time we think of it. Imaginegetting a car from the factory with a 455 cubic inch engine init!This car Read more...

Car Chase Classics
By Mark Mahorney, Sat Dec 10th
I hit my teenage years in the early 80s about the same timeVCRs and independent video rental shops came to every small townin America. This was before yogurt shops and tanning booths hit,and Read more...

 
 
 

Ford GT 40 Replica

Tecnologia Pesante

Benvenuto nel nostro sito

 
 
 
 
 

 

Google

 

 

 

 

 

 

 

 

More on street and concerning rods
Site Powered by GoFTP FREE Version