rat rods hot rods street rods guide

 

 

 

Building A Bmx Bunny Hop Trainer.
By Written by, Thu Dec 8th

Learning to get enough height to start grinding and stalling canbe a real challenge for the beginning BMX biker. Here issomething that can be built and used to get the heights needed.The best part about it that it is cheap and easy to build.Materials can found at your local lumber/hardware store. Thematerials needed are as follows; 2-2"x4"x3'board 1-1/2"x8' pieceof hard plastic water pipe. 20-2" finish nails. 1-3/4"x1'x4'plywood 4-3"deck screws

With the materials assemble as the diagram illustrates. "You cansee the detailed picture at www.evilbmx.biz under articles page".

The 3" deck screws come up from the bottom of the plywood intothe 2"x4"x3' boards. The finishing nails are nailed into theboard about ½" to ¾" The nails provide a place for the plasticpipe to hang. You can put the nails 1" apart going up on eachside.


Using

 

 

 
 
  Here are some articles to start with..  
 
 

Make A "black Cab" Driver Your Guide To London
By Gregory Hudson, Thu Dec 8th
Drivers of the classic Black Cab spend most of their daily livestrundling through the streets of London. They are a rare breedand the cars they drive are just as full of character andpersonality Read more...

Weather And Car Cover Fundamentals
By Matthew C. Keegan, Tue Dec 6th
Selecting a car cover for your truck, van, SUV, or passenger caris a matter of finding one that fits your car and going withthat one, right? Well, there is a lot more to it than simplypurchasing a Read more...

 
 
 

Ford GT 40 Replica

Tecnologia Pesante

Benvenuto nel nostro sito

 
 
 
 
 

 

Google

 

 

 

 

 

 

 

 



Check here for rods and further information concerning street
The Fastest SFTP (SSH) on the planet FREE Go FTP Program