Building A Bmx Bunny Hop Trainer.
By Written by, Thu Dec 8th

Learning to get enough height to start grinding and stalling canbe a real challenge for the beginning BMX biker. Here issomething that can be built and used to get the heights needed.The best part about it that it is cheap and easy to build.Materials can found at your local lumber/hardware store. Thematerials needed are as follows; 2-2"x4"x3'board 1-1/2"x8' pieceof hard plastic water pipe. 20-2" finish nails. 1-3/4"x1'x4'plywood 4-3"deck screws

With the materials assemble as the diagram illustrates. "You cansee the detailed picture at www.evilbmx.biz under articles page".

The 3" deck screws come up from the bottom of the plywood intothe 2"x4"x3' boards. The finishing nails are nailed into theboard about ½" to ¾" The nails provide a place for the plasticpipe to hang. You can put the nails 1" apart going up on eachside.

Using